News Details

Triple Frequency Induction Withstand Voltage Test Device 5kVA/360V/150Hz

Precautions:

1. This equipment is designed for short-time operation, so it is not allowed to work at rated capacity for a long time, especially not allowed to run exceeding the rated current to prevent overheating.

2. For newly installed transformers or those not used for a long time, before operation, use a 1500 megohm meter to measure the insulation resistance between coils and between coils and ground respectively. Only when the resistance is not lower than 0.5 megohm can it be used.

3. During use, the current-raising transformer and the operation console must be reliably grounded to ensure safety.

4. When raising current, it should be done slowly and evenly, and avoid excessive vibration during handling.

5. The contact surface between the voltage regulator and the carbon brush should be kept clean. If necessary, wipe it clean with cotton yarn dipped in 90% alcohol.

Triple Frequency Induction Withstand Voltage Test Device 5kVA/360V/150Hz

Technical Parameters:

1. Input voltage: Three-phase 380V 50HZ

2. Output voltage: Single-phase 0～300V/0～500V/0～1000V (continuously adjustable), frequency: 150HZ

3. Output capacity: 0～1000kvA, harmonic distortion: ＜1%

4. No-load operation time: ≤5 minutes 

5. Duration of test object at rated voltage: 40 seconds

6. Load characteristics: resistive, inductive, capacitive all acceptable

Product Aliases:

Triple frequency generator, induced voltage triple frequency generator, triple frequency power supply generator, test triple frequency transformer device, triple frequency induction withstand voltage generator, triple frequency test transformer, triple frequency tester, triple frequency induction withstand voltage tester, voltage transformer frequency multiplication AC withstand voltage test

After-sales Service Commitment:

1. Service purpose: rapid response, proper handling, thoughtful service.

2. Service goal: customer satisfaction is our ultimate goal.

3. Service efficiency: If equipment fails during or after the warranty period, after receiving notification, maintenance personnel will arrive at the site within 12 hours and begin repairs.

4. Service principle: The product has a free warranty period of one year. During the warranty period, the supplier will repair or replace parts damaged due to quality reasons free of charge. For damage to parts outside the warranty period, only the cost of parts will be charged. For equipment damage caused by user factors, the supplier will charge at cost for repairs or parts.